Lines Matching full:power
299 59 1 Channel [0] TX power level for Scan (0 means do not change - other values:1-5)
506 uint8 txPowerAttenuation; /* TX power level to be used per channel scanned. */
507 /* If 0, leave normal TX power level for this */
1111 Power Save dependent activities are an exception to this, therefore
1112 the host must exit Power Save mode by issuing the SET_PS_MODE command
1115 to enter the configured low power state.
1149 Desc: This command turns ON/OFF Power save protocol on the WiLink.
1150 After HW configuration, FW sends Null data packet to the AP with Power
1173 StationPowerSaveMode_e mode; /* This field specifies the future Power save*/
1175 /* When set, Power save protocol is enabled. */
1176 /* When cleared, Power save protocol is */
1183 /* Power Save Protocol mode.*/
1188 /* with the Power Save bit set, indicating that*/
1189 /* the station is to go into Power Save mode. */
1267 uint8 txPowerAttenuation; /* TX power level to be used for sending probe requests*/
1269 /* If 0, leave normal TX power level for this channel. */
1457 uint8 txPowerLevelDbm; /* TX power level in dbm */
