Lines Matching full:wpa
358 * fixed WPA PSK update through ctrl_iface for the case where the old
371 if WPA-None (adhoc) is used (pairwise=NONE in that case)
448 * reject WPA/WPA2 message 3/4 if it does not include any valid
449 WPA/RSN IE
569 the new AP is using different WPA/RSN IE
574 * allow fallback to WPA, if mixed WPA+WPA2 networks have mismatch in
575 RSN IE, but WPA IE would match with wpa_supplicant configuration
581 * fixed RSN pre-authentication (it was broken in the clean up of WPA
612 roaming from WPA enabled AP to plaintext one
622 layer (Ethernet) header during WPA and EAPOL/EAP processing; this
656 * allow non-WPA modes (e.g., IEEE 802.1X with dynamic WEP) to be used
657 with drivers that do not support WPA
732 * driver_madwifi: fixed WPA/WPA2 mode configuration to allow EAPOL
743 * fixed association with IEEE 802.1X (no WPA) when dynamic WEP keys
782 is set to an empty string, any SSID will be accepted for non-WPA AP
814 * fixed WPA/RSN IE verification in message 3 of 4-Way Handshake when
834 * fixed non-WPA IEEE 802.1X to use the same authentication timeout as
835 WPA with IEEE 802.1X (i.e., timeout 10 -> 70 sec to allow
855 WPA-NONE, i.e., TKIP or CCMP with a fixed key (based on psk) and no
860 supports WPA-None)
910 interface can distinguish plaintext and IEEE 802.1X (no WPA)
915 * driver_ndis: added legacy WPA capability detection for non-WPA2
986 * fixed couple of unaligned reads in scan result parsing to fix WPA
989 * added support for LEAP with WPA
1003 * set pairwise/group cipher suite for non-WPA IEEE 802.1X to WEP-104
1028 verify both WPA and RSN IEs, if present, not only the selected one;
1032 * fixed WPA msg 3/4 processing to allow Key Data field contain other
1033 IEs than just one WPA IE
1048 WPA
1051 currently, this can be used only for non-WPA IEEE 802.1X mode, but
1052 eventually, this is to be extended to support full WPA/WPA2 once
1106 WPA Group Key messages when pairwise keys are used (without this,
1143 * fixed RSN IE and WPA IE capabilities field parsing
1150 * fixed WPA-PSK only mode when compiled without IEEE 802.1X support
1158 - EAP-MD5 (cannot be used with WPA-RADIUS)
1174 * use module prefix in debug messages (WPA, EAP, EAP-TLS, ..)
1175 * added support for non-WPA IEEE 802.1X mode with dynamic WEP keys
1177 EAPOL-Key frames instead of WPA key handshakes)
1181 * fixed wpa_supplicant to ignore possible extra data after WPA
