Lines Matching full:card
61 not the card).
69 The 3C905B card actually provides a method to program the flash memory
70 while it is resident on board the card itself; if someone would like to
98 5. Put the PROM in the ethernet card, boot and enable 'boot from
119 algorithm if the card has multiple media ports.
147 doesn't have this option, remove the card, start the system, shut down,
148 install the card and restart (or switch to a different PCI slot).
152 unless the card is set internally to the MII transceiver, it will only
161 So, the solution that I've used is to internally set the card's nvram
165 card to an appropriate value, either configurable by the user or chosen
171 Thereafter, the card should accept the larger prom image.
173 The driver should choose an appropriate transceiver on the card. However,
174 if it doesn't on your card or if you need to, for instance, set your
175 card to 10mbps when connected to an unmanaged 10/100 hub, you can specify
200 programmed into a register in the card's NVRAM that was reserved for
201 LanWorks PROM images to use. When the driver boots, the card comes
205 card has based on the 3c905b's MediaOptions register. This driver isn't
215 says that, at least with the card that I have, the device driver in the
248 a3c90x_internal_IssueCommand - sends a command to the 3c905b card.
250 windows onboard the 3c90x. The bottom 16 bytes of the card's
255 card's onboard nvram. This is NOT the BIOS boot rom. This is
256 where the card stores such things as its hardware address.
258 card's nvram, and recomputes the eeprom checksum.
260 card's nvram. Used by the above routine.
262 card's nvram. Used by the above routine.
301 You have to take the chip off the card and boot the system once using
303 the card and change some setting in it, correcting the problem. After
