Home | History | Annotate | only in /external/u-boot/board/solidrun/clearfog
Up to higher level directory
NameDateSize
clearfog.c22-Oct-20204K
kwbimage.cfg22-Oct-2020246
MAINTAINERS22-Oct-2020145
Makefile22-Oct-2020106
README22-Oct-20201.3K

README

      1 Update from original Marvell U-Boot to mainline U-Boot:
      2 -------------------------------------------------------
      3 
      4 Generate the U-Boot image with these commands:
      5 
      6 $ make clearfog_defconfig
      7 $ make
      8 
      9 The resulting image including the SPL binary with the
     10 full DDR setup is "u-boot-spl.kwb".
     11 
     12 Now all you need to do is copy this image on a SD card.
     13 For example with this command:
     14 
     15 $ sudo dd if=u-boot-spl.kwb of=/dev/sdX bs=512 seek=1
     16 
     17 Please use the correct device node for your setup instead
     18 of "/dev/sdX" here!
     19 
     20 Boot selection:
     21 ---------------
     22 
     23 Before powering up the board, boot selection should be done via the SW1 dip
     24 switch (0: OFF, 1: ON):
     25 
     26  - SPI:     00010
     27  - SD/eMMC: 00111
     28  - M.2 SSD: 11100
     29  - UART:    01001 [1]
     30 
     31 [1]: According to SolidRun's manual, 11110 should be used for UART booting on
     32      the ClearFog 'Pro' variant.
     33      However, this doesn't work (anymore) at least on Rev. 2.1 (but '01001' as
     34      mentionend for the 'Base' variant does).
     35 
     36 Boot from UART:
     37 ---------------
     38 
     39 Connect the on-board micro-USB (CF Pro: CON11, CF Base: CON5)
     40 to your host.
     41 
     42 Set the SW1 DIP switches to UART boot (see above).
     43 
     44 Run the following command to initiate U-Boot download:
     45 
     46   ./tools/kwboot -b u-boot-spl.kwb /dev/ttyUSBX
     47 
     48 Use the correct UART device node for /dev/ttyUSBX.
     49 
     50 When download finishes start your favorite terminal emulator
     51 on /dev/ttyUSBX.
     52